About this tool
Since June 2024 the U.S. Army has used a one-site tape test to estimate body fat for its Army Body Composition Program. Army Directive 2023-11 replaced the older neck, waist and hip method with a single abdominal measurement at the navel combined with body weight.
Soldiers who exceed the height and weight screening table are taped, and the result is compared with the maximum allowable body fat for their age and sex. This calculator reproduces that arithmetic so you can check where you stand before an official assessment.
How it works
Enter your sex, age, body weight and the abdominal circumference measured horizontally at the navel. US units are the default because the Army equations use pounds and inches; metric entries are converted first.
Like the official worksheet, the calculator records the weight to the nearest pound and the abdomen down to the nearest half inch, applies the sex-specific one-site equation and rounds the result to the nearest whole percent. It then compares that number with the maximum allowable body fat for your age group from AR 600-9.
Example
The Army's own example for a man: weight 210 lb and abdomen 35 in. The equation gives , which rounds to 17%. For a man aged 28–39 the maximum is 24%, so he meets the standard.
For a woman weighing 165 lb with a 30 in abdomen: , which rounds to 26%. The limit for women aged 21–27 is 32%.
Assumptions and limits
This is an unofficial estimate. Only a measurement taken by trained personnel under AR 600-9 counts: the tape is applied three times and averaged, and units may also use supplemental methods such as DEXA or InBody when available. Under Army Directive 2025-17, Soldiers who score at least 465 on the Army Fitness Test with at least 80 points in every event are exempt from the tape assessment.
The equations estimate body fat from population averages and can be several points off for an individual. Rules change over time, so confirm current policy with your unit or the Army Body Composition Program.
Frequently asked questions
What is the Army body fat standard?
AR 600-9 sets the maximum allowable body fat by age: men 20% (17–20 years), 22% (21–27), 24% (28–39) and 26% (40 and over); women 30%, 32%, 34% and 36% for the same groups.
Where is the abdomen measured for the one-site tape test?
Horizontally around the abdomen at the level of the navel, against the skin, at the end of a normal relaxed breath out. The tape should be level all the way around and snug without compressing the skin.
Is the one-site tape test the same for men and women?
The measurement site is the same, but each sex has its own equation. The women's equation uses smaller coefficients and a higher starting value, reflecting typical differences in fat distribution.
Can I still be taped with the old neck and waist method?
No. During the first year after Army Directive 2023-11 the multi-site method was allowed for confirmation tapes, but since 8 June 2024 the one-site tape test is the only authorized circumference method.
What happens if I exceed the standard?
A Soldier who exceeds the limit is flagged and may request a supplemental body fat assessment if one is reasonably available. Those who do not pass are enrolled in the Army Body Composition Program, which includes nutrition and exercise support.
Link with your values
Add these parameters to this page’s address to open it with the values filled in, for example to share a calculation or to link to it from an AI assistant. The result is calculated in the browser: the page HTML shows an example for the default values, and the tool sets the data-url-params attribute once the link’s values are applied.
| Parameter | Value | If omitted |
|---|---|---|
units | metric or imperial | set by the first measured value |
sexSex | one of: male, female | default male |
age_yearsAge (years) | whole number; allowed 17–80 | required |
weight_kgweight_lbweight_st + weight_lbweight_lb + weight_ozWeight (kg) | number; any unit in the name: _mg, _g, _kg, _oz, _lb, _st, _ug, _t; allowed 30–300 kg (metric), 66.1386786555–661.386786555 lb (imperial) | required |
abdomen_cmabdomen_inAbdomen at the navel (cm) | number; any unit in the name: _mm, _cm, _m, _km, _in, _ft, _yd, _mi, _nmi; allowed 20–250 cm (metric), 7.87401574803–98.4251968504 in (imperial) | required |
Examples
?sex=female&age_years=32&weight_lb=145&abdomen_in=31?sex=male&age_years=40&weight_kg=88&abdomen_cm=94
Write decimals with a point. Encode a space as %20, + as %2B, # as %23 and & as %26.
Result elements: [data-result-block="army-body-fat"]