About this tool
This double click test checks whether a mouse button registers one press as two. Click the test area normally with any button: left, right, middle (wheel), back or forward. The tool times every press and flags presses that follow the previous one faster than a person clicks on purpose.
An unwanted double click usually comes from switch chatter, also called bounce: worn or oxidized contacts inside the microswitch open and close more than once during a single press. A chattering left button can open files you only meant to select, drop items you are dragging, or fire twice in a game. The test helps you confirm the fault before you clean the switch, change the mouse's debounce setting or make a warranty claim. It pairs well with the click speed test, which measures how fast you click rather than how cleanly the mouse registers it.
How it works
Pick a threshold, then click the test area at a normal pace with the button you want to check. Each press is compared with the previous press of the same button. If the interval is shorter than the threshold, the press counts as a suspected double click. A press that comes less than 10 ms after the same button was released also counts, whatever the threshold, because no finger can release and press a switch that fast. This second rule catches chatter while you hold a button, for example during a drag.
The results table shows presses, suspected double clicks and the shortest interval for each button you have used, and changing the threshold recounts the whole session. Open the event log to see the last 20 presses with the time since the previous press, the time since the previous release and how long the button was held. To check dragging, hold the button for a few seconds and then release it. If the switch chatters, the log shows an extra press with a release gap of a few milliseconds.
Example
You click the left button 100 times at a comfortable pace with the 80 ms threshold. Most intervals fall between 150 and 400 ms, but two presses arrive 12 ms and 18 ms after the previous one. The tool reports 2 suspected double clicks in 100 presses and a shortest interval of 12 ms, which points to a chattering switch.
A fast deliberate double click usually lands about 80 to 200 ms apart, so avoid double-clicking on purpose during the test, or lower the threshold to 50 ms. Intervals under 30 ms almost always come from the hardware, not from your finger.
Assumptions and limits
The browser receives mouse events after the mouse firmware and the operating system have processed them. Many gaming mice filter chatter with a debounce time in firmware, so a mouse can pass here at one debounce setting and fail at a lower one. Timing precision depends on the browser, which may round event times to a millisecond or more. Back and forward buttons do not reach some browsers, notably Safari on macOS. Touch taps are not counted. Results stay on this page and are not uploaded.
Frequently asked questions
Why does my mouse double click when I click once?
Most often the switch under the button is wearing out. Its metal contacts lose spring tension or oxidize, so they bounce and make contact more than once per press. Less common causes are a debounce time set too low in the mouse software, a dirty switch, and a faulty cable or wireless receiver.
Which threshold should I choose?
Start with 80 ms for ordinary clicking. If you click very fast on purpose, for example with jitter or butterfly clicking, choose 30 or 50 ms so your own clicks are not flagged. Choose 100 or 150 ms only if you click slowly and want to catch milder cases; quick deliberate double clicks may then be flagged too.
How do I fix a mouse that double clicks?
First rule out the computer: try another USB port or computer, update or reset the mouse software, and raise its debounce time if it has that setting. Compressed air blown into the button gap sometimes helps for a while. A lasting fix is a replacement switch or a warranty claim, since chatter is a hardware defect. Run the test again after each change to compare the counts.
The test passes, but my mouse still double clicks. Why?
Chatter often comes and goes with wear, pressure and temperature, so a short test can miss it. Click for a few minutes, include long holds and drags, and press the way you do when the problem appears. If your mouse software has profiles with different debounce times, test with the profile you normally use.
Does the double-click speed setting in Windows or macOS matter?
No. That setting decides how close two clicks must be to open a file, but this test times each press directly, so changing it does not affect the intervals or the counts.
Link with your values
This tool takes no link parameters: open the page as it is.